How sound leaks through walls, doors and gaps
A solid wall can still let a thud out. Sound doesn't need a hole it can see. It needs a weak part, and most rooms have several.
Mass helps, but it isn't everything
The soundproofing source puts it bluntly: "Barring an airtight vacuum, mass is the only way to stop sound."1 Heavy, dense layers hold sound back better than light ones. That's why a thin partition lets more through than a thick one.
But mass only counts where it's actually continuous. A heavy wall with a hole in it behaves like a light one at the hole.
Small gaps count for a lot
The sound ratings source has numbers that surprise people. It says "A small gap in the wall can greatly reduce the STC rating."2 In its example, a wall that could cut 40 decibels was tested with openings. A 5% opening dropped the figure to 13 decibels. A 0.1% open area, it says, cut the figure from 40 to 30.2
That 0.1% case, it adds, is typical of walls where caulking hasn't been applied well.2 A seam you'd never notice is enough.
Where the weak spots usually are
These are the places to check, starting with the ones that cost nothing:
- Door edges and the bottom gap. A door that doesn't seal lets air, and sound, past it.
- The door itself. The source says "Solid wood doors are a better sound barrier than hollow doors."1
- Outlets and switches. The ratings source lists back-to-back electrical boxes, untreated recessed lights and unsealed pipes as parts that "offer flanking paths for sound."2
- Where wiring, pipes and ducts pass through a wall. The soundproofing source says sealing around them with acoustical caulk or spray foam "will significantly reduce unwanted noise."1
- Vents. A vent that links two rooms is an open path for air, and for sound.
- Windows. A window is thin and often leaks at its edges.
Look along a closed door with the light on the other side. Where light shows, sound passes.
Curtains and covers
A heavy curtain over a window or door can seem like a quick fix. The soundproofing source names the main limit: curtains have no seal at the edge.1 A curtain that stops short of the frame leaves the gap open.
What sealing can and can't do
Sealing deals with the airborne route. It does little for vibration that runs through a floor or frame. Why a sealed room can still thud is on the airborne versus vibration page.
Your electrical work is a separate matter. Don't open an outlet box, move a switch or add a circuit yourself. That's licensed electrical work, so ask a licensed electrician. Anything that changes a wall's structure goes to a qualified tradesperson too.
Questions before you buy
Ask a seller or installer these:
- What is the rating for, and which test was used?
- Does the rating include the door frame and the gaps, or just the panel?
- What's the plan for the edges, the seams and the services that pass through?
- Does the product change how the room is used or ventilated?
Don't block a vent that a heater, fan or electrical gear needs. Ask the maker or a tradesperson.
Remember the ratings guide. It says the STC "very roughly reflects" the cut a partition gives, and that it suits speech better than machinery or music.2 That's our reading, not the source's: a ball strike might fall nearer the second case, but the source never mentions golf.
The hitting area stays as the maker says. Keep it clear, and never pad the walls in a way that cuts the swing room below the maker's figure.
Notes and sources
- Soundproofing, Wikipedia
- Sound transmission class, Wikipedia