Skip to content

Why a ball hitting a screen is loud, and what changes it

Checked November 19, 2026

The screen is often the first place to look, but it isn't always the whole story. A hit on a screen sets several things moving at once, and the screen is only one of them.

What happens at the screenBall strikes the screenScreen moves and pushes the airSome energy reaches the wall or frameRoom and structure carry the sound on
Where the energy of a hit goes.

What the screen does

An impact screen has a hard job. It has to stop a fast ball, then let it drop or roll away. In doing so, it moves, and a moving surface pushes on the air. That push is the bang you hear.

The screen also passes movement to whatever holds it. Frames, ropes, hooks and the wall behind can all pick up some of the blow. When they do, they can carry it on into the building as vibration.

So there are two things to separate. The sound the screen makes in the air, and the movement it hands to the frame and wall.

What can change the loudness

No single figure fits every screen. It depends on the product and the room. The questions below decide it. Put them to a maker:

  • What is the screen made of, and how many layers does it have?
  • How tight is it hung? A loose sheet and a tight one move differently.
  • Is there a gap behind it, or does it touch the wall?
  • What's behind the gap? A hard, bare surface behind the screen reflects sound back.
  • How is the frame fixed to the building, and does anything soft sit between them?

A maker's manual may also say how far the screen has to sit from the wall and what covers the surface behind it. Follow that for your own model. Real balls rebound, so you should never swap a manual's wall covering for something thinner to save noise.

The room behind the screen

Dense material helps stop sound leaving a space. The soundproofing source says dense material helps stop sound waves leaving through a wall, ceiling or floor.1 The wall behind a screen is a source wall in that sense. A thin, hollow wall lets more through than a heavy one.

If the wall is part of your house structure, any change to it is a job for a qualified tradesperson. Don't drill, cut or add weight to it on a guess.

Softening the sound in the room

A soft layer near the screen can calm what the room does with the bang. The same source says sound-absorbing material controls the reverberant sound level inside a room.1 That's about how loud and ringing the room is inside. It doesn't stop the frame passing movement to the wall.

A room with hard surfaces keeps the bang going longer. That lingering is called reverberation.2 Softer surfaces shorten it. See the room's echo.

Separating the screen from the structure

The thud side is about the connection. The soundproofing source calls this decoupling: a gap between a sound source and the mass next to it, so sound has no direct path across.1

For a screen, that idea means looking at where the frame touches the building. Another source names rubber pads and mechanical springs as passive ways to reduce vibration.3 Whether a given mount can use them depends on the maker's design, so ask first. Mount instructions come first, and anything structural goes to a tradesperson.

What you can reasonably expect

A screen change alone rarely settles a noise complaint. If the thud is the complaint, look to the floor and the frame. If the bang is, look at the room's walls, doors and gaps, covered in how sound leaks through walls, doors and gaps.

Ask any seller for the test behind a noise claim. What was measured, how far from the screen, and with what kind of ball and club? A claim with no answer to those isn't one you can compare.

Never hit into a bare wall or window, and keep to the maker's required swing space whatever you change.

Notes and sources

  1. Soundproofing, Wikipedia
  2. Reverberation, Wikipedia
  3. Vibration isolation, Wikipedia